Tag: UniFi
UniFi Link to heading
This section tracks configurations for the Ubiquiti UniFi network stack, focusing on wireless optimization and site management.
🎛 Controller & Management Link to heading
- Network Application: Hosting strategies (Self-hosted/Docker vs. Cloud Key) and backup routines.
- Port Profiles: Managing VLAN tagging, trunking, and switch port isolation.
- Security: Guest portal configuration, radius profiles, and MAC filtering.
🛠 Infrastructure & Tuning Link to heading
- Wireless: Radio optimization, transmit power balancing, and channel width strategies (HT20/40/80).
- Roaming: Min RSSI settings and Fast Roaming (802.11r) tuning.
- Hardware: Firmware management and adoption workflows for APs and switches.
📚 External Resources Link to heading
- Ubiquiti Help Center - Official support articles and guides.
- Ubiquiti Community - User forums and release channels.
- UniFi - Adopt a disconnected device
Problem A device is shown offline even though it was adopted in the past. This has happened to me when I changed the IP of the UniFi Network Controller. Solution SSH into the USG device and run the following command …
- UniFi - Device Adoption
Introduction Adoption is the process of connecting a device to the UniFi application that will manage it. All UniFi Access Points (APs), cameras, phones, and other devices (excluding consoles) are designed to make the …
- UniFI - Get Current Value of set-inform
Problem I need to get the current value of set-inform on my USG. Solution SSH Into USG and run the command info and look for the line Status. Example admin@ubnt:~$ info Model: UniFi-Gateway-4 Version: 4.4.57.5578372 MAC …
- UniFi - Remote Adoption (Layer 3)
Introduction Layer 3 adoption is the process of adopting a UniFi device to a remote or cloud-hosted UniFi Network Application. This is only recommended for advanced users, or those adopting devices when using Official …
- UniFi - Reset Device
Problem I need to reset a UniFi device, maybe it's failing adoption or it became unresponsive. Solution SSH into the UniFi Device and type in set-default Important Running set-default immediately reset the device and …
- UniFi - Troubleshooting - Failed to save network
Problem I was trying to make a change to one of the Networks from the UniFi Controller, and I was unable to save the settings due to the following error: I managed to grabbed the response from the Developer Tools, …